This model replaces the pads with equivalent line integrals around the pad rim. The behavior is exactly the same as bga-11.fe.

- The top and bottom pad facets are not onerous in this series of models, especially with "no_refine" to keep their numbers down and no freedom for the contact lines on the pads to move off the pad rims. But this model illustrates how one could remove the pad facets, if one should want.
- The lower pad facets make no contribution to either energy (having tension 0) or to volume (since z = 0). Recall that the default volume calculation is done by integrating z dx dy over the surface. Hence the lower pad facets can simply be deleted from the datafile.
- The upper pad makes a contribution to the volume, which can be replaced by integrating z x dy around the top pad rim edges. This is implemented by a "content" integrand for boundary 1. (I use "content" as the general-dimensional word for volume.) Note the integrand has a minus sign, which is necessary because of the Evolver's convention for the sign of content integrands: edges oriented as positive boundary of facets that are postive boundary of a body contribute positive content. Here the top edges have negative orientation in the definition of the body faces, so the negative sign is necessary. You should always check to make sure your volumes come out to what you expect on the initial datafile.
- The upper pad makes no contribution to surface tension energy, but
it does make a contribution to gravitational energy. On facets, the
gravitational energy is calculated as the integral of G*density*z
^{2}/2 dx dy, so an equivalent edge integral is G*density*z^{2}/2*x dy. Note that I am using the fact that dy slices are horizontal.

BGA example home page Next BGA page

Previous BGA page

Surface Evolver home page

Ken Brakke's home page

This page last modified June 2, 2013

Susquehanna University assumes no responsibility for the content of this personal Web page. Please read the disclaimer.